Forfatter Emne: Kodning af nøgle til Centrallås  (Læst 1439 gange)

Noerregaard

  • Gæst
Kodning af nøgle til Centrallås
« Dato: 15. Marts 2010, 10:55 »
Hej alle

Jeg er indehaver af en peugeot 605 fra '95.
Efter at have stået uden batteri længe har nøglen og bilen nu ingen forbindelse. Det er derfor nu ikke muligt at låse bilen, da det manuelle system heller ikke virker. Er klar over at der er forskellige metoder på hvordan man får nøglen og bilen til at finde hinanden

- Mit spørgsmål er til jer: Hvordan får jeg bilen til at registrere nøglen?

Venlig hilsen
Patrick

silverfox

  • Gæst
RE: Kodning af nøgle til Centrallås
« Svar #1 Dato: 15. Marts 2010, 12:53 »
Hvis du kan komme ind i bilen, skal du sætte nøgle i tændingen, drejen nøglen over på tænding(uden at statrte) og  holde knappen inde i ca  5 sekunder og derefter starte bilen. Så bør den være kodet igen.

Noerregaard

  • Gæst
RE: .
« Svar #2 Dato: 19. Marts 2010, 09:57 »
Kan du eventuelt uddybe det lidt mere? - Hvilken knap er det? - det virkede nemlig ikke i første omgang.

Venlig hilsen

carsten0

  • Gæst
RE: Kodning af nøgle til Centrallås
« Svar #3 Dato: 22. Marts 2010, 17:31 »
CENTRAL DOOR LOCK (1 BUTTON PLIP KEY)

1. Ensure all the doors are unlocked using the key.

2. Press and hold the plip key button until the LED stops flashing.

3. After releasing the button, the LED will light constantly.

4. Press the Plip Button once, and the LED will extinguish.

5. Open the door and hold the Plip key near the Ignition switch, and press the plip button one time.

6. Turn the ignition ON, and wait 10 seconds, then turn ignition OFF.

7. After 5 seconds the Plip should now operate.

CENTRAL DOOR LOCK with DEADLOCKING (2 BUTTON PLIP KEY)

1. Ensure all doors are unlocked using the key.

2. Press and HOLD the large plip key button while the LED flashes continuously for 20 seconds. After 20 seconds press the small deadlock button once while still holding the large button.

3. The LED will stop flashing.

4. Release the large button and the LED will light constantly.

5. Press the large button once and the LED will go out.

6. Open the door and hold the Plip key near the Ignition switch and press the large plip button once.

7. Turn the ignition ON, wait 10 seconds and then turn the ignition OFF.

8. After 5 seconds the Plip should now operate

Noerregaard

  • Gæst
RE: .
« Svar #4 Dato: 13. April 2010, 14:28 »
Hej alle

Tusind tak for de fine svar, desværre virker det ikke.
- er der andre idéer?

Bilen er en Peugeot 605 2.0 fra '95 med den mindste udstyrspakke og med kodet startspærre.

Venlig hilsen
Patrick