Peugeot Planet Problems (Cant communicate with ecu)

[gtrig]

Hello everyone.
So I bought this Chinese Lexia3 cable. it came with 2 dvds one having diagbox and one having Lexia3 and pp2000.

After a lot of sweat I managed to install diagbox in an Oracle VirtualBox VM and managed to activate it and update it.
I also managed to connect the interface , install its drivers and to read its firmware which was 4.3.0 with the interface checker.

So I happily went to connect it to my newly acquired 307 1.6 which has some Antipollution fault... and.... it cant communicate with the vehicle. I tried virtualy everything... with no luck.
I tried running with admin rights... nothing
I tried running with all ignition switch states... nothing
I even tried reinstalling Everything including the vm and diagbox, or pp2000 as stand alone.... nothing....
Although every time I see the interface connecting... and the pp also sees the interface (cause if it doesnt its quiting with a failure message)... I keep getting the message that the ecu hasnt replied.
I even tried to connect to an other 307 2.0 but still nothing

Is my interface not working? how can I test this?
The only thing I havent tried and I would if I could is to install win xp on my laptop... which I actually did... but I couldnt find the drivers for any of the laptops devices so I scraped that...

Unfortunately I dont speak danish cause I am Greek and I am new in the country.
I am currently staying at holbaek and I am looking for someone around me that has pp2000 installed to check my unit with his installation and/or have a look in my car.

Any help would be appriciated.
Thank you very much.

[pug407aut]

Try downgrade firmware to 4.22 or less

[superpjok]

Hi!
Where are you located ?
Might be helpfull to know:)
if you are close to me we could put my i/f on your computer .
Regs

[martin306xsi]

Mon ikke det er Holbæk, det skriver man ihvertfald

[gtrig]

yes I am at holbaek but I could take the car and come to you if you are within 100km radius.

[superpjok]

Hi!
Unfortunatly i am living in Jutland, Hope someone closer to you can help you out ;-)
Regs

[406st]

Maybe a stupid question, but worth considering... Did you remember to turn the key to the second point - just before ignition?

Claus

[gtrig]

yep I certainly have. I have tried everything. with car on with car off, with ignition on with ignition on... just nothing ... I have also tried on different car... still nothing.
I also tried different versions of peugeot planet. so what I am thinking now... is to find someone near Kobenhavn or holbaek or roskilde that has one running to check my interface unit if it is working.

[Holt]

It's well known that the cable with the usb connector is of very poor quality, try using the other one (there is normally a long and a short delivered)
Or you can look here for a recipe for a home made replacement.

 http://www.peugeotforums.com/forums/detailing-gadgets-29/new-usb-cable-pp2000-interface-25512/


Holt

[gtrig]

I dont think that there is a problem in the usb cable cause I can read the interface with the interface checker. the problem is that the ecu is not being read. after all if the cable was broken I wouldnt be able to start the pp2000 cause it requires the interface to be connected to start.
the problem is that when I select the vehicle I am getting an error saying that the communication with the vehicle was not possible.